
( Brand: Coherent ), ( Part Type: Laser )
Below the hour meters. Included is an optics bench for beam control, remote systems control panel and schematics for customizing to your application. On consignment.
That also allows use on 3 phase 208 vac instead of 480 vac below note the optic bench with solenoid controlled beam selectors and interface to scope output, if desired.
Termination is in bare 4 wire. In the foreground, the optics bench for control of beam selection.
Below the argon and krypton warning labels. Both are kept in standby mode, and can be accessed instantly, individually. Below due to the power of this laser system, it requires water cooling of both the plasma tubes and the transistorized current pass bank.
10,000 Millie watts . Internal bucking boosting transformer allows accommodation of input voltage s of approximately vac. Below under the hood, about 10,000 Millie watts of total producible laser light from the two side by side plasma tubes shown.
2 gallons per minute or 45 psi, and a suitable drain for low pressure, 1 gallon per minute is required. All functions are fully working to original manufacturer specs. Below the card cage and control electronics.
Gas refillable. It may, or may not repair, but doesn't at this time.
Below laser selection, power, on time can be bypassed for continuous operation. One laser operates at time, although they both can be in standby mode, for near immediate access to the other colours.
Mercia graze Garcia's talk. Schematics supplied. The photos and above are of the actual unit being offered. The key is lost, so the key switch bottom left corner had to be removed and bypassed.
Schematics supplied.
Laser tubes of this era, if currently in operating condition, such as these, often run upwards of 12,000 hours. Danker Velma's. A filtered supply of approximately Below the power supply controls.
Both tubes have intact vacuum and gas, and power supply and interlocks operate.
The unit is sold and represented as fully functional at time of shipping but due to the inherent fragile nature of elector optical systems, the unit is sold as is. Below one of the perfect condition, pristine Brewster windows, showing tube integrity.
Below the electrical supply requirements 3 phase 208 vac, 35 amperes. Coherent really over engineers lasers from this era. Beam selection controls are on the portable, umbilical ed remote control, pictured below.
Below the other Brewster window, again demonstrating tube seal integrity. For below with the front panel down, accessing the water cooled electronics. Use without external scope not included, for applications such as light shows where beam access is desired to be interfaced in cadre approved manners, requires bypass of interlocks.
It may be possible to get as much as 9 watts argon and 4 watts krypton, at maximum current, with just cleaned optics, but the confirmed power is as stated.